There’s nothing worse than not being able to transfer your embroidery pattern. Sometimes you can’t see through the fabric to trace and other times the pattern is so intricate, tracing feels next to impossible!
Sulky Sticky Fabri-Solvy is the best solution I have found!
My love for Sulky Sticky Fabri-Solvy began when I started stitching embroidered photographs. I love seeing a photograph come to life in another art form. It’s my favorite way to capture my most cherished memories.
I have made several embroidered photographs and I even offer embroidery kits to make your very own embroidered photograph! I have discovered the easiest way to get the pattern onto my fabric without losing any of the important little details is by using Sulky Sticky Fabri-Solvy. This stuff is magical! Your Custom Embroidered Photograph Kit will come with your pattern printed onto this magical Sulky Sticky Fabri-Solvy.
You can send a sheet of Sulky Sticky Fabri-Solvy through your printer and get your design printed right onto it! Then you just peel off the back and stick it onto your fabric!
How to Use sulky sticky fabri-solvy
1. Choose your pattern.
2. Print your pattern onto the Sulky Sticky Fabri-Solvy.
3. Peel off the release sheet and stick your pattern onto your fabric where you want your design to be. The best part is, if you happen to place your pattern in a spot you don’t like, you can always peel it off and stick it in a new spot!
4. Grab an embroidery hoop and place your fabric in it. TIP: Don’t pull the fabric too tight in your hoop, or the fabric will bunch when you take it out. Keep the tension of your fabric the same as the tension of the Fabri-Solvy.
5. Stitch your design! Keep in mind that the Sticky Fabri-Solvy is in fact sticky, so it is normal to have a sticky residue on your needle. This can seem annoying, but I assure you it will be worth it! Sticky Fabri-Solvy is the easiest way to get an intricate design onto fabric. Especially when using dark fabric!
It’s so easy to use! Just stitch through both layers: The Sulky Sticky Fabri-Solvy and your fabric.
6. When you are done, take your design out of your embroidery hoop and run the Sulky Sticky Fabri-Solvy under warm water for 1 – 2 minutes., or until the Fabri-Solvy is completely dissolved.
7. Place the embroidery between two towels and press down on the embroidery to remove excess water. Then, lay flat to dry completely.
This is a video tutorial that will show you how to completely remove the Sulky Sticky Fabri-Solvy.
For more detailed instructions, grab a Custom Embroidered Photograph Kit from me. Your kit will come with everything you need to embroider your favorite photograph including your pattern printed onto Sulky Sticky Fabri-Solvy, instructions with pictures and video tutorials, fabric, thread, needles, an 8 inch hoop, and felt to back your embroidery hoop.